Wheel forgings vertical vehicle processing matters needing attention

Wheel forgings with the wide application of lifting equipment, but also in the pursuit of their own quality quality requirements, so in the premise of improving quality forgings factory in vertical wheel processing must be standardized, today xiaofian for you to put forward the following points for attention.

1. The wool surface of the wheel forgings is not allowed to be directly placed on the working surface, and the pad iron or spiral top support should be applied. Do not use the worktable for other operations such as hammer correction of wheel forgings, welding wheel forgings, etc.

2, alignment wheel forgings can only move the table at low speed rotation alignment, not high-speed alignment.

3, start and stop car processing table, work table start and stop handle can only be pulled by hand, strictly prohibited with foot pedal.

4. When the workbench rotates, it is not allowed to do beam lifting and tool rest moving quickly.

5. When moving the beam, loosen the clamping device first, and clamp it immediately after moving it. After each drop of the beam, it should rise a little to eliminate the gap between the lead screw and the nut.

6. Gravity cutting is not allowed under the condition that the ram of vertical tool rest and side tool rest extends very long. When using vertical tool rest for machining, especially for gravity cutting, the beam should be lowered as close to the working position as possible.

7, wheel forgings for intermittent cutting processing, to appropriately reduce the feed and table speed.

8. When the wheel forgings change speed, the joystick must be pushed to the specified position. If the gear is not meshed well, it should be adjusted by micromotion after work, and it is not allowed to forcibly pull the "on/off" handle of the worker's table.